Total Output Power 215 Watts The total output power is the actual power out put measured during final test. Test conditions: mono operation 16 ohm load 1kHz at 0.1% total harmonic distortion, line voltage maintained at 120 volts RMS, 60Hz. This power is equivalent to the sum of both channels when driving 8 ohm loads in stereo mode.
Output Power (dual channel) 100 Watts (minunim) into 8 ohm load Sine wave continuous average power output per channel with both channels driven over a power band from 20Hz to 20kHz. The maximum total harmonic distortion at any power level from 250 milliwatts to 100 watts is no moret han 0.08%.
Output Power (bridged mono) 100 Watts (minunim) into 16 ohm load Sine wave continuous average power output driving monaural load (bridged) over a power band from 20Hz to 20kHz. The maximum total harmonic distortion at any power level from 250 milliwatts to 150 watts is no moret han 0.08%.
Intermodulation Distortion Less than 0.02% from 250mW to rated power
(SMPTE method, 60Hz & 7kHz, 4:1 ratio)
Rise Time (small signal) 4 Microseconds
Small Signal 1Hz - 85kHz, +0,-3dB, Frequency Response 20Hz - 20kHz, +0,-0.25dB,
DC Offset Voltage Less than 20 millivolts at output terminals
Hum and Noise Levels Better than 103dB below 100W/8 ohms
(unweighted, 20Hz to 20kHz)
Input Impedance 15k ohms & 240pF bal. or unbal. per channel
Input Sensitivity 0.92Vrms for rated output; volt. gain=30 (29dB)
Damping Factor 400:1 (ref. 8 ohms) below 1kHz
Power Requirements 400 watts for rated 8 ohm power. 120, or
240VAC, 50-60Hz
Dimensions:
Height 1.75 inches
Width 19 inches
Depth 11 inches behind front panel (11.9"overall)
Weight 14lbs. (6.4kg) net, 19lbs. (8.6kg) shipping
NOTES
Due to continuous product improvements, all specifications and features are subject to change without notice.
BGW Systems Inc.